Internal Combustion Engine
Upendra Rajak; Prerana Nashine; Tikendra Nath Verma
Abstract
The unvarying condition diesel engines used for commercial applications, transportation and industries lead to the crisis of petroleum fuel diminution and ecological squalor caused due to exhaust gases. Therefore, in this paper optimization of the use of MSB in naturally aspirated, direct injection diesel ...
Read More
The unvarying condition diesel engines used for commercial applications, transportation and industries lead to the crisis of petroleum fuel diminution and ecological squalor caused due to exhaust gases. Therefore, in this paper optimization of the use of MSB in naturally aspirated, direct injection diesel engines, parameters of pure diesel (D100), 80% diesel + 20% microalgae spirulina (B20), 60% diesel + 40% microalgae spirulina (B40) and pure microalgae spirulina biodiesel (B100) were investigated at various fuel injection pressures (FIP) of 18 to 26 MPa and stationary injection timings (23.5° b TDC). The result shows that optimum effect can be obtained in 22 MPa FIP, with B20 bio-diesel without compromising the performance against diesel. B20 blend presented less NOX and smoke emissions by 13.7% and 22.2% respectively with no significant change in engine performance when compared to diesel at full load operating condition. The simulation and experiment results are verified at the same operating conditions.
Internal Combustion Engine
A. Shaafi; M. J. Noroozi; V. Manshaei
Abstract
In this computational research, the separate and simultaneous impacts of diesel direct injection timing, fuel spraying cone angle, and hydrogen gas addition on combustion characteristics, output emissions, and performance in a single-cylinder direct injection diesel engine was studied. In order to conduct ...
Read More
In this computational research, the separate and simultaneous impacts of diesel direct injection timing, fuel spraying cone angle, and hydrogen gas addition on combustion characteristics, output emissions, and performance in a single-cylinder direct injection diesel engine was studied. In order to conduct the simulations, valid and reliable models for combustion, break-up, and for turbulence was used. The effects of fifteen fuel injection strategies based on characteristics such as time of fuel spraying (-15, -10 CA BTDC, and TDC) and nozzle cone angle (105, 115, 125, 145, and 160 degrees) under neat diesel combustion and diesel-hydrogen combustion engine operations conditions were explored. The obtained results indicated that the addition of H2 due to significant heating value has increased indicated power and improved indicated specific energy consumption at the expense of NOx emissions but considerably decreased CO and soot emissions simultaneously. By advancing injection timing, maximum pressure peak point, maximum temperature peak point, and maximum heat release rate peak point have increased and caused lower indicated specific energy consumption. However, using a wide spray angle (e.g., 160 cone degrees), resulted in lower indicated power and higher indicated specific energy consumption due to more fuel could spray in regions with lower oxygen concentrations compared to baseline operation case.