Forming
Mehdi Bostan Shirin; Ramin Hashemi; Ahmad Assempour
Abstract
An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. ...
Read More
An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. In the developed unfolding IFEM, the meshed part is properly fold out on the flat sheet and treated as a 2D problem to reduce the computation time. The large deformation relations, nonlinear material behavior and friction conditions in the blank holder zone have also been considered to improve the accuracy and capability of the proposed IFEM. The extended strain-based forming limit diagram based on the Marciniak and Kuczynski (M-K) model has been computed and used to predict the onset of necking during sheet processing. The EFLD is built based on equivalent plastic strains and material flow direction at the end of forming. This new forming limit diagram is much less strain path dependent than the conventional forming limit diagram. Furthermore, the use and interpretation of this new diagram are easier than the stress-based forming limit diagram. Finally, two applied examples have been presented to demonstrate the capability of the proposed approach.
Forming
Hashem Zamanian; Mehdi Bostan Shirin; Ahmad Assempour
Abstract
In this work, an inverse finite element formulation was modified for considering material anisotropy in obtaining blank shape and forming severity of deep drawn orthotropic parts. In this procedure, geometry of final part and thickness of initial blank sheet were known. After applying ideal forming formulations ...
Read More
In this work, an inverse finite element formulation was modified for considering material anisotropy in obtaining blank shape and forming severity of deep drawn orthotropic parts. In this procedure, geometry of final part and thickness of initial blank sheet were known. After applying ideal forming formulations between material points of initial blank and final shape, an equation system was obtained in terms of unknown initial positions on the blank sheet. Initial positions of material points were obtained by solving this equation system. In this algorithm, the Hill's anisotropic plasticity and associated plastic flow rule were used. Strain distribution on the final part was obtained by comparing the initial blank and final part. The method was applied for the simulation of drawing an orthotropic blank to a rectangular cup. Accuracy of the presented method was evaluated by comparing the results with numerical forward method and experiment results.
