Plasticity
Sadjad Pirmohammad; Sobhan Esmaeili-Marzdashti; Arameh Eyvazian
Abstract
In this article, crashworthiness performance and crushing behavior of tapered structures with four internal reinforcing plates under axial and oblique dynamic loadings have been investigated. These structures have a tapered form with five cross sections of square, hexagonal, octagonal, decagon and circular ...
Read More
In this article, crashworthiness performance and crushing behavior of tapered structures with four internal reinforcing plates under axial and oblique dynamic loadings have been investigated. These structures have a tapered form with five cross sections of square, hexagonal, octagonal, decagon and circular shape. In the first step, finite element simulations performed in LS-DYNA were validated by comparing with experimental data. The code generated in LS-DYNA was then used to investigate energy absorption behavior of the tapered structures. Response surface methodology and historical data design technique were employed to optimize the cross section perimeter (tapered angle) of the tapered structures by considering two conflicting crashworthiness criteria including EA (energy absorption) and PCF (peak crushing force). The optimization results showed that the optimal tapered angle enhanced by increasing the number of cross section sides (or number of corners). Then, the optimized tapered structures with different cross-sections were compared with each other using a ranking method called TOPSIS to introduce the most efficient energy absorber. The decagonal structure was finally found to be the best energy absorber.
Plasticity
F. Moayyedian; M. Kadkhodayan
Abstract
One of the new research fields in plasticity is related to choosing a proper non-associated flow rule (NAFR), instead of the associated one (AFR), to predict the experimental results more accurately. The idea of the current research is derived from combining von Mises and Tresca criteria in the places ...
Read More
One of the new research fields in plasticity is related to choosing a proper non-associated flow rule (NAFR), instead of the associated one (AFR), to predict the experimental results more accurately. The idea of the current research is derived from combining von Mises and Tresca criteria in the places of yield and plastic potential surfaces in rate-independent plasticity. This idea is implemented using backward Euler method in non-linear finite element simulation. The results are compared with the experimental data for an internally pressurized thick-walled cylinder and it is demonstrates that, using the proposed NAFR in rate-independent plasticity, the experimental results could be predicted more accurately. Finally, it can be said that the current research confirms the results of the previous works on rate-dependent plasticity (viscoplasticity) in steady state conditions.
